Fang's blog

  <- Lab1                                                                Lab3 -> Download Full PDF report  (LAB2) _____________________________ LAB 2 ESP32 Digital Inputs and Outputs  Objective : - To learn how to use GPIO port on the ESP32 controller to input and output digital value. - Able to use ESP32 to read input like switch and touch sensor and show output value. - Learn how to code using Arduino and print output. Equipment and components : •  ESP32 DOIT DEVKIT V1 Board •  3x 5mm LED •  10k Ohm resistor •  Pushbutton •  Breadboard •  Jumper wires •  Potentiometer Introduction :       ESP32 is a series of low-cost, low-power system on a chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth. The ESP32 seri...

                                                                                                                                                  Lab2 ->                                                           Download Full PDF report  (LAB1) _____________________________ LAB 1 D’ARSONVAL GALVANOMETER  Objective : - To find the internal resistance and the current sensi...