Fang's blog

<- Lab3 Download Full PDF report  (Mini Project) _____________________________ Video Presentation of Mini Project MINI PROJECT : 3D Smart House Model Objective : - To learn how to use an ESP32 microcontroller to control the electronic component by using the local network. -  Able to use Blynk app to view and control electronic circuit status on phone using ESP32. - Build a 3D house model and able to use the ESP32 to toggle fan, light and alarm(buzzer). - To implement the ultrasonic sensor and LDR into the project. Equipment and components : •  ESP32 DOIT DEVKIT V1 Board • 4 x 5mm LED •  10k Ohm resistor •  Light Dependent Resistor (LDR) •  SR04P Ultrasonic Ranging Module •  L298N Motor Driver / Stepper Driver (2 Channels) •  3V Miniature Brush Motor with wire leads •  Piezo Buzzer with Wires •  Breadboard •  Jumper wires •  Android Device with Blynk app installed Project Synopsis :       This 3D Smart Hou...

<- Lab2                                                      Mini Project -> Download Full PDF report  (LAB3) _____________________________ LAB 3  Wireless control and Light sensor Objective : - To learn how to connect a ESP32 microcontroller to the local network -  Able to use Blynk app to view and control ESP32 status on phone -Troubleshoot connection of ESP32 to the network by using a correct token key Equipment and components : •  ESP32 DOIT DEVKIT V1 Board •  3x 5mm LED •  10k Ohm resistor •  Light Dependent Resistor (LDR) •  Breadboard •  Jumper wires •  Potentiometer •  Android Device with Blynk app installed Introduction :       ESP32 is a series of low-cost, low-power system on a chip microcontroller with integrated Wi-Fi and dual-mode Bluet...

  <- Lab1                                                                Lab3 -> Download Full PDF report  (LAB2) _____________________________ LAB 2 ESP32 Digital Inputs and Outputs  Objective : - To learn how to use GPIO port on the ESP32 controller to input and output digital value. - Able to use ESP32 to read input like switch and touch sensor and show output value. - Learn how to code using Arduino and print output. Equipment and components : •  ESP32 DOIT DEVKIT V1 Board •  3x 5mm LED •  10k Ohm resistor •  Pushbutton •  Breadboard •  Jumper wires •  Potentiometer Introduction :       ESP32 is a series of low-cost, low-power system on a chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth. The ESP32 seri...

                                                                                                                                                  Lab2 ->                                                           Download Full PDF report  (LAB1) _____________________________ LAB 1 D’ARSONVAL GALVANOMETER  Objective : - To find the internal resistance and the current sensi...